3 GAL High solid self levelling epoxy coating High solid self levelling epoxy coating is a two component self-leveling epoxy coating that is 100% solid. With its opaque color and glossy finish, it can be used to restore floors or protect new floors. Passeport Élite Industrial Epoxy provides excellent physical and chemical resistance providing durability while maintaining its artistic taste. This system can be used with a primer coating, followed by 2 topping coats. APPLICATION - Showrooms, - Stores - Commercial areas, - Living spaces - Warehouse - Industrial production areas ADVANTAGES - Low odour, Solvent-free - 100% solids with an esthetic finish - Seamless - Good chemical and physical resistance - Easy to clean, bacteria and moisture resistant surface
MIXING Passeport Élite Industrial Epoxy is supplied in factory proportioned quantities, greatly reducing the risk of applicator error during mixing. Step 1 - Mechanically premix PART A (resin) with an appropriate slow speed drill equipped with a Jiffy Mixer, for 1 minute. Step 2 - Slowly empty entire content of PART B into container holding PART A and continue to mix slowly for 3 minutes until uniform consistency in texture and color is achieved. Avoid unnecessary entrapment of air during mixing. Make sure to scrape walls and bottom of container with straight edged trowel at least once to ensure homogeneous mix. Make sure to empty ALL contents of PART B into PART A to avoid system weakening or incomplete curing. DO NOT MIX MORE MATERIAL THAN CAN BE APPLIED WITHIN WORKING TIME LIMITS. APPLICATION Passeport Élite Industrial Epoxy should be applied at ambient and surface temperatures between 15-28°C and humidity below 80%. Passeport Élite Industrial Epoxy is applied with a rubber squeegee and back rolled to remove squeegee lines and smooth out coating. Additional coats may be applied when surface is tack-free (roughly 8 hours). Do not exceed first 24 post-application hours for recoating.