MD Super Décapant Strong Stripper SolvEco with Methylene Chloride 18.9L (1)

WARNING : Although this product does not display a "skull and crossbones" symbol in accordance with current regulations (RPCCC) due to its low acute toxicity, it remains a dangerous product that must be handled with care. The methylene chloride it contains, in addition to being a suspected human carcinogen, can act as a simple asphyxiant and cause death if used improperly. Adequate ventilation is necessary to mitigate this risk and reduce your exposure to vapors. AT A MINIMUM, an open window with additional ventilation is required. UNDER NO CIRCUMSTANCES should this product be used in a closed or poorly ventilated room (such as a bathroom), as methylene chloride evaporates quickly and, being heavier than air, can displace oxygen from the breathable area. DIRECTIONS Carefully read all the directions and warnings on the back prior to using the product. TO OPEN, follow the procedure shown on the cap. CAUTION! Contents may be under pressure. To avoid splatters when opening, place a rag over the safety seal and open carefully. Close cap tightly after each use, clean excess product and store container in a cool place. Always wear protective gloves and clothing as well as eye and face protection. For a reliable protection, use Super Remover Stripping Gloves. The time required for the paint stripper to work will vary depending on the type of coating and the number of layers to be removed. WOOD SURFACES: When most of the work is done, use a Super Remover stripping pad and a small amount of paint stripper to remove the rest of the coating while following the wood grain. If necessary, use the SolvÉco Wood Preparator to clean the surface thoroughly. Do not use this product on fiberglass, vinyl, linoleum, rubber, acrylic and plastics. STEPS: 1. Pour a thick coat of SolvÉco Strong Stripper directly onto the surface to be stripped. 2. Spread evenly and rapidly with a paint brush, using a single stroke in a single direction, to create a uniform thick layer of 1/8 inch or more. 3. Let stand for at least 15 minutes. Do not rush this step. Do not manipulate the paint stripper after its application to the surface being stripped, as this will interfere with the vapor barrier. 4. Use a plastic, metal or wooden spatula or scraper to test a small area and to see if the paint stripper has penetrated all layers. If not, let the paint stripper rest on the surface for a longer period. 5. When you notice that the product has reached its maximum effect for a single application, remove the residues. If some coating still needs to be removed, repeat steps 1, 2 and 3.