Cabot Pro VT Solid Color Acrylic Decking Stain This stain + sealer offers long-lasting waterproofing and exceptional washability with advanced UV protection against sun damage. - Our strongest weather barrier blocks the most UV rays - Maximum scuff resistance - Covers old stain of all kinds and mismatched boards
APPLICATION DIRECTIONS. Before You Begin: - Surface should be clean, porous and free of any previous finishes - For concrete: sprinkle a few drops of water on the surface; if they are quickly absorbed then the surface is ready to prep - Let wood dry in the open air for 3-5 days - Always apply to a small test area and allow to dry - Cover nearby bushes and flowers - Apply when air and surface temperatures are between 10 °C and 32 °C SURFACE PREPARATION - If needed, sand with 80-100-grit (120-180 grit for rougher surfaces) sandpaper to remove any loose wood fibers - Replace severely damaged or rotting boards - Clean with Cabot Wood Cleaner to remove dirt, grime, mildew and other contaminants - If needed, brighten with Cabot Wood Brightener to remove rust stains, tannin bleed or discoloration - If needed, remove old water- or oil-based coatings with Cabot Wood Stripper and neutralize with Cabot Wood Brightener - Check the label for additional and specialized directions APPLICATION STEPS - Apply with nylon or polyester brushes, stain pads or professional spray equipment - When spraying, always back-brush immediately. To ensure desired appearance and proper drying time, always finish a small test area before proceeding. Do not overapply. - Shake and stir thoroughly before and during use. If project requires more than 1 container, blend all containers together to ensure uniformity. - Apply to small sections at a time (1-3 boards); start at one edge of the board and work end-to-end, following through to the end of the boards to avoid lap marks - One-coat application may be used on new wood; two coats for worn or weathered surfaces and for optimum performance